ATSB issues report on in-flight upset involving Boeing 747-400
Following an ATSB investigation into an in-flight upset involving a Boeing 747-438 near Hong Kong in 2017, Qantas has incorporated more complex stall warning recovery events in recurrent lesson plans for its Boeing 747 flight crews.
The incident occurred in April 2017. While descending toward Hong Kong, air traffic control instructed the flight crew to hold at a waypoint. When entering the holding pattern, the aircraft’s aerodynamic stall warning stick shaker activated a number of times and the aircraft experienced multiple oscillations of pitch angle and vertical acceleration. During the upset, some passengers and cabin crewmembers struck the cabin ceiling and furnishings, sustaining minor injuries.
The ATSB found that while planning for the descent, the flight crew overwrote the flight management computer-provided hold speed. After receiving a higher than expected hold level, the flight crew did not identify the need to re-evaluate the hold speed. This was likely because they were not aware of a need to do so, nor were they aware that there was a higher hold speed requirement above flight level 200.
Prior to entering the hold, the speed reduced below both the selected and minimum manoeuvring speeds. The crew did not identify the low speed as their focus was on other operational matters. The ATSB also found that due to a desire to remain within the holding pattern, and a concern regarding the pitch-up moment of a large engine power increase, the pilot flying attempted to arrest the rate of descent prior to completing the approach to stall actions.
In addition, the pilot monitoring did not identify and call out the incomplete actions. This led to further stall warning stick shaker activations and pilot induced oscillations, which resulted in minor injuries to four cabin crewmembers and two passengers.
The ATSB found the flight crew had limited training and guidance for stall warning recovery techniques at high altitude or with engine power above idle. Inconsistencies were also found in flight crew training of the awareness of the need to re-evaluate holding speed when there are changes in altitude, especially above flight level 200.
Subsequent to the incident, Qantas provided retraining for all Boeing 747 flight crews in stall warning recovery scenarios and amended ground school lesson plans to ensure flight crews were adequately prepared to recover from stall warning activations at high altitudes or with engine power above idle.
Qantas also amended flight crew training manuals relating to hold speed selection and updated ground school lesson plans and information to ensure standardised training and holding pattern training. In addition, Qantas proactively applied these measures across its Boeing 737 and 787 fleets.
The post ATSB issues report on in-flight upset involving Boeing 747-400 appeared first on ASN News.
The content for this post was sourced from www.Aviation-Safety.net